![]() # If this folder does not yet exist, it will be created. file.list <- list.files(cropped.folder, pattern = "csv$", full.names = TRUE) # define folder where to save the amplifier drift corrected file. # Here we use the cropped.folder with the cropped measurements. # create file list with all cropped files that need amplifier drift corrections. If not already theĬase, we strongly recommend renaming the raw data files accordinglyīefore continuing with this forceR vignette.įirst, we set the folder containing the example data as theĭata.folder (make sure this fits your local path, ![]() Of the same measurement associated with each other. The number (in this caseĠ001) is used to keep data files, log files, and PDF files If you decide to use your own files, consider thatįorceR generally expects file names to start with leadingĭigits specifying the measurement number (E.g.Ġ001_G_maculatus.csv). ![]() Zenodo in case you have accidentally overwritten anything This folder nowĬontains every file that is needed and has been produced during theĬreation of this vignette, so you can always restore the files from Zenodo onto your hard drive, unzip the files and store the folder Pleaseĭownload and unzip the content of the example_data.zip file from Methods in EcologyĪnd Evolution XXX: pp.XX-XX. Please cite the following publication when using theĪnd forceR: a mobile setup and R package to measure andĪnalyze a wide range of animal closing forces. Instead of loading files, bite series are Ideas across while allowing for fast calculations.Īt the end of this vignette you will find a self-sufficient workflowĮxample that runs all forceR commands after file loadingĪnd drift corrections. ![]() Limited data set of 8 bite force measurement files is used to get the This vignette guides you through all functions of the package.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |